Hinged Doors Used in the Atlanta Home

All hinged doors have the same basic framework, sometimes hidden under a solid veneer. The framework consists of two stiles that run vertically, and two or more rails that run horizontally. The hinges are on one side and the latch and lock are on the other.

The two types of wood doors are paneled and flush. A paneled door has a visible frame of stiles and rails that supports two or more panels. If multi-paneled, the door has mullions and extra rails.

A flush door is faced with hardboard or wood veneer covering the frame. A flush door for exterior use should have a solid core made from several layers of hardwood or particle board. An interior flush door usually has a hollow core formed from a frame surrounding a grill-like structure.

The door is hinged to a frame, consisting of jambs, casing, stops, sill and threshold. The jambs form the sides and head of the frame. The casing acts as trim and as a support for the jambs. The stops are wood strips the door fits against when closed. In exterior doors, a dill fits between the jambs, forming the frame bottom. The threshold, or saddle, is fastened to the sill.

Repairing Loose Doors

If a door is too small for its frame, install weather-stripping.
If a loose door is causing latch problems, you may be able to adjust the latch.

Repairing Binding Doors

Check for a buildup of dirt or paint.
Adjust the fit of a sagging door.

Repairing Warped Doors

If the warp is minor, adjust the stop or hinges to compensate.

Repairing Latch Problems

When a latch refuses to work, check either the fit of the door or of the lockset.

Removing a Door

Remove the hinge pins by closing the door securely (place a wedge under it or have a helper hold the door.)
Gently tap on the bottom of the lowest pin or on the underside of its head using a hammer and a nail or nailset. This drives the pin up and out of the hinge barrel.
Remove the middle pin and then remove the top pin.
Lift the door off its hinges.
To reinstall the door, replace the top pin first, then the middle and then the bottom.
Drive the pins home only after the hinges are correctly aligned.
Leave the pins a little loose so they'll be easier to remove in the future.

Quieting Squeaky Hinges

Coat with silicone spray or light penetrating oil.
If squeaking persists, remove the pin and clean the pin, barrel and hinge leaves with steel wool.
Coat them lightly with silicone spray or light penetrating oil and replace the pin.

Tips to Keep in Mind if Replacing a Door

Sand or plane any excess wood up to 1/16 inch on the door's top and bottom, up to 1/4 inch on the sides. Saw off any excess that's greater and sand.
Leave a 1/16 inch clearance around the door on the top and sides. Bottom clearance should be at least 1/2 inch, more if you want to clear a rug.
Bevel the lock side of the door 1/8 inch so the door will clear the jamb as it opens and closes. If the door is already beveled, install it so the beveled edge is on the lock side.
When installing a hinge on the door, leave at least a 3/4 inch margin between the door edge and the hinge leaf edge.
If you're hanging a new door in an existing frame, use the existing hinges if possible.
Place the top hinge about 7 inches below the top of the door, the other one 11 inches above the bottom of the door. If you're installing a third hinge, center it between the two.

You should read these tips to help you before and after your purchase of your Atlanta dream home, and if you are looking for you next Atlanta home give the SeeGeorgiaRealEstate Team a call and our Atlanta Realtors will help you find your next home. Weather you are searching for Atlanta real estate, Cumming Georgia real estate or Lake Lanier Real Estate or Alpharetta real estate, or any of the surrounding metro Atlanta areas, we are your answer to finding that perfect home or property.